Overtime, Long Days and Turnaround: Putting a Clock on Your Day Rate
How to define the day your rate covers, set overtime that holds up on set, handle meals and turnaround, and keep a twelve-hour shoot from becoming a free four hours.
By The Rate Guide StaffQuoting7 min readUpdated Oct 20262 sources
In this article · 13 sections
- Define the day in the quote
- Decide when the clock starts and stops
- Set the overtime rate
- If you're an employee, the law sets the floor
- Meals
- Turnaround
- Equipment doesn't go into overtime
- Flat days and "whatever it takes"
- Approval on set
- A worked example
- When a producer pushes back
- Before sending the quote
- The day needs an end

A day rate with no hours attached has no limit. The producer reads "$800/day" and pictures the call sheet. You read "$800/day" and picture ten hours. On a shoot that runs fourteen, one of you is wrong, and you find out who when the invoice goes in.
Overtime terms settle that before the shoot. They also protect the thing a day rate can't price: the sleep between today's wrap and tomorrow's call.
Define the day in the quote
Write the length of the day next to the rate, every time:
Director of photography — $1,100 per 10-hour day
Ten hours is the common baseline for freelance video and commercial crew outside union agreements. Twelve-hour days are also common, especially on narrative work, and some clients will ask for a flat twelve from the start. Either can work. A rate with no stated hours can't.
The day-rate calculator works out an hourly figure by dividing your day rate by ten. If you quote a different day length, change the math to match.
Decide when the clock starts and stops
Most overtime arguments are about the edges of the day, not the middle.
Settle these in the quote:
- Start: your call time, not the time the first shot rolls
- End: when you are released or finish wrapping out, not when the AD calls wrap on the last shot
- Load-in and load-out: inside the day when you're carrying your own kit
- Travel: inside the day or billed separately; see prep, travel and wrap
- Meal break: whether a 30-minute unpaid meal is excluded from the hours
Union contracts often measure rest "portal to portal," from the moment you leave the studio gate to the moment you return. You don't need that wording, but you need some definition of the edges that both sides read the same way.
Set the overtime rate
A common freelance structure:
| Hours | Rate |
|---|---|
| 1–10 | Day rate |
| 11–12 | 1.5 × hourly |
| 13+ | 2 × hourly |
The hourly figure is the day rate divided by the base hours. At $800 for ten hours:
- Hourly: $80
- Time and a half: $120
- Double time: $160
A thirteen-hour day bills $800 + 2 × $120 + 1 × $160 = $1,200.
Some crew bill overtime in half-hour increments, some in full hours. Pick one and write it down: "Overtime billed in half-hour increments, any part of an increment counts as the full increment."
These multipliers are a convention, not a law, for independent contractors. They hold up because clients recognize them from payroll and union work. State them plainly and most producers won't argue.
If you're an employee, the law sets the floor
Crew on payroll may be covered by wage-and-hour law, and some states set overtime by the day.
California, for example, requires nonexempt employees to receive one and a half times the regular rate for hours over eight in a workday, double time over twelve, and premium pay on the seventh consecutive day in a workweek. California Labor Commissioner
Those rules start counting at eight hours, not ten. A "10-hour day" rate quoted to a California payroll company has to be converted into an hourly rate that complies with state law, which is why production payroll services often express crew rates as an hourly figure with a guaranteed number of hours.
If a job is on payroll, ask how the payroll company will calculate your rate. If a union agreement covers the job, its overtime rules apply. Union crew should confirm terms with their local.
Meals
A long day needs food, and the timing matters as much as the meal.
Common terms for freelance crew:
- First meal within six hours of call
- Second meal six hours after the first meal ends
- A walking lunch or craft service does not count as a meal break
Union agreements enforce meal timing with escalating meal penalties. As one example, the 2021 IATSE Basic Agreement increased penalties for repeated violations in the same week. Motion Picture Editors Guild summary
A freelancer can borrow the idea without the rate card: "If a meal is not provided within six hours of call, a $25 meal penalty applies for each half hour of delay." Whether you enforce it is up to you. Writing it down tells the producer you track it.
Turnaround
Turnaround is the rest between one day's wrap and the next day's call. It is the term crews fought hardest for in recent union negotiations.
The 2021 IATSE Basic Agreement set a ten-hour minimum daily turnaround for most crew on covered productions, and a 54-hour weekend rest after a five-day week. Motion Picture Editors Guild summary
Freelance quotes outside a union agreement rarely address turnaround, and the gap shows up on multi-day jobs. A fourteen-hour Monday followed by a 6 a.m. Tuesday call leaves no time to sleep after the drive home.
Add a line:
Minimum 10 hours between wrap and next call. A shorter turnaround is billed as overtime on the following day, starting at call.
That makes a short turnaround cost money, which gives the producer a reason to schedule around it.
Equipment doesn't go into overtime
Kit and equipment packages bill by the day, not the hour. A camera package that runs for thirteen hours is still one day's rental. Labor overtime and equipment days are separate lines; see how to charge a kit fee.
The exception is an equipment package held over to another calendar day. That is another rental day.
Flat days and "whatever it takes"
Some clients offer a flat rate with no overtime: "$1,000 for the day, however long it goes." Others offer a flat twelve.
A flat twelve is a defined day with a higher rate, and it can be a fine deal. A flat day with no end time is a rate with no hours, and your hourly rate falls with every hour the shoot runs long.
If you accept a flat day, cap it:
Flat rate covers up to 12 hours. Hours beyond 12 billed at $150/hour.
Approval on set
Overtime is easier to collect when someone approved it while it was happening.
Before the shoot, ask who can approve overtime: usually the producer or the production manager, sometimes the client. When you hit the end of your base hours, tell that person. A single text works: "We're at 10 hours. Overtime starts now at $120/hour."
Keep your own times: call, meals, wrap, release. Compare them with the call sheet and production report. If the production uses timecards, sign yours the same day.
A worked example
A gaffer quotes a two-day commercial job:
Gaffer — $900 per 10-hour day
Overtime: 1.5× after 10 hours, 2× after 12, half-hour increments
Minimum 10-hour turnaround
Meals within 6 hours of call
Day 1 runs from a 7 a.m. call to an 8:30 p.m. release, with a 30-minute unpaid lunch: 13 hours worked.
- Base: $900
- Hours 11–12: 2 × $135 = $270
- Hour 13: 1 × $180 = $180
- Day 1: $1,350
Day 2's call is 6 a.m., giving 9.5 hours of turnaround instead of 10. Under the quote, the half hour of invaded rest bills as overtime on Day 2:
- Base: $900
- Turnaround penalty: 0.5 × $135 = $67.50
- Day 2: $967.50 (if Day 2 wraps in 10 hours)
The total is $2,317.50 for a job the producer may have budgeted at $1,800. The terms were in the quote, so the gaffer has the paperwork behind every line.
When a producer pushes back
"Everyone works a 12 on this show."
"That's fine. My 12-hour rate is $1,080, with overtime after 12."
"We'll take care of you on overtime."
"Thanks. Let's put the overtime rate in the confirmation so accounting has it."
"Can you waive the turnaround penalty? It's only half an hour."
"I can push call by thirty minutes instead. That keeps us at ten hours."
"We don't pay overtime to freelancers."
"Then let's agree on a flat rate for a 12-hour day with an hourly rate beyond that."
Before sending the quote
Confirm:
- The rate states the number of hours it covers
- The quote defines when the day starts and ends
- Overtime multipliers and increments are written
- Payroll and union jobs follow the applicable law or agreement
- Meal timing is stated
- Minimum turnaround is stated, with what happens if it's invaded
- Equipment is billed by the day, separate from labor overtime
- Any flat rate has a cap
- You know who approves overtime on set
The day needs an end
A day rate without hours lets the production decide what your day is worth after the fact.
Put the hours next to the rate. Price the hours past them. Protect the rest between days. The producer will schedule better when long days cost money.